GridlineElectric Works Book a visit
Menu

Eight plates from the equipment file

Consumer units, distribution boards, conduit runs, cable ducting and junction boxes, photographed on real sites. Where a manufacturer's marking is legible on a component it is a record of the equipment, not an endorsement of it, and no plate is presented as work carried out by this firm.

  • A grey weatherproof junction box open on a bench, its lid resting beside the gasketed base.
    01 Weatherproof junction box, open
  • A row of miniature circuit breakers beside a residual current device in a consumer unit, each way numbered on the label strip below.
    02 Consumer unit, ways numbered
  • Two consumer units side by side on a wall, one populated with breakers and the other blanked off ready for further circuits.
    03 Two boards, one ready for circuits
  • Galvanised conduit runs fixed to a concrete soffit, with a cable hanger clamped to one of them.
    04 Conduit run at ceiling level
  • A cable drum and steel support frames set up along a concrete tunnel wall during a conduit installation.
    05 Cable drum and support frames
  • Red cable ducting laid in a curve along a footway beside stacked pipe and bagged material.
    06 Cable ducting on the footway
  • Steel conduits stacked on racking inside a narrow concrete service void.
    07 Conduit racked in a service void
  • Metal enclosures and meters mounted on a board against a corrugated workshop wall, with conduit dropping to each one.
    08 Distribution board, workshop wall

Start with a diagnostic visit

Readings first, written down and shown, with the options set out before anything is fitted.

Book a visit Contact the workshop

Notes from the workshop, occasionally

An email when a code change affects domestic boards, or when a seasonal check is worth a reminder. No fixed schedule, and one link in every message removes an address from the list.

This is a demo design, not a real business.Have it rebranded as yours for $500 from EZWebee.