A Foundry Row shop with a circuit sheet for every home
Dale Ferris started Gridline Electric Works after watching Richmond homeowners caught between two bad options: unlicensed handymen cutting corners behind the drywall, and franchise outfits selling $8,000 upgrades on fear. Every home we work on now has its own sheet: what is in the panel, what we measured, what we changed and when.
The firm runs on one rule: no part goes in before a reading explains why it is needed. When we open an older panel, we show you the thermal image, the torque check and the National Electrical Code section involved, and we separate what is a safety fix today from what can wait for a future upgrade. Nobody should pay for a guessed-at breaker and then pay again when the guess was wrong.
Panels are drawn, not described. A sketch of your breaker panel with every circuit numbered means the next electrician starts where the last one finished. On permitted work our office pulls the city permit, books the utility disconnect and reconnect, and meets the inspector on site, because an unpermitted panel swap can surface years later in an insurance claim or a house sale.
Three promises on every call
-
A written flat-rate quote
You approve the exact total in writing before work starts. If a stubborn wall cavity takes an extra hour to fish, the figure does not move.
-
A two-hour arrival window
No waiting in all day for a van. We book a two-hour window and send a text about thirty minutes before the electrician pulls up.
-
A 3-year written warranty
Every breaker, receptacle, surge unit and panel we supply and install carries a written 3-year labour and materials warranty.
Four steps from first call to a closed permit
-
Step 1
Enquiry
Use the contact form or call the office. For an EV charger or a panel upgrade, send a photo of your breaker panel; you can also name a preferred electrician.
-
Step 2
Load check or diagnosis
A licensed electrician traces the circuit or works out your home’s amperage demand, then talks you through the options in plain words.
-
Step 3
Quote signed
Once you sign the flat-rate quote, most outlets, circuits, lighting and repairs are done on the spot from a stocked van. Anything that has to be ordered is named now.
-
Step 4
Test, label, close out
Every circuit is tested under load, the breaker directory is relabelled, the floor is vacuumed, any city inspection is finalised, and the changes go on your home’s sheet.
How a date gets confirmed
Sending a request does not lock in a time. Nora reads every request, checks the electrician’s schedule and any permit or utility lead time, then replies to confirm your two-hour arrival window. Until you hear from her, the date is not booked.
Start with a diagnostic visit
Readings first, written down and shown, with the options set out before anything is fitted.