GridlineElectric Works Book a visit
Menu

Licensed, bonded & insured · Richmond

Electrical work tested first, priced before it starts

Overcrowded 100-amp panels, garage EV charger circuits and breakers that will not stop tripping: Gridline Electric Works sends state-licensed electricians who measure before they quote, pull the permit where code calls for one, and label every circuit before they leave.

Book a visit View services & upfront pricing
A wall-mounted distribution board carrying meters and metal enclosures, with conduit risers running up the workshop wall beside it
Distribution board and conduit risers, first checks marked

What an electrician checks first

  1. 01 Main switch and meter enclosure
  2. 02 Conduit riser at high level
  3. 03 Grounding, bonding and cable gland
  4. 04 Branch circuits and directory labels

These four points are checked on every diagnostic call, before a cover comes off or a single part is priced.

Residential & light-commercial services

Each job opens with a load or diagnostic check and a written flat-rate price, so nobody is left watching an hourly clock. The services page sets out what each one covers.

  • Troubleshooting & code repairs

    Tripping breakers, dead outlets and flickering lights traced to the cause.

    $129

  • Surge protection & GFCI/AFCI retrofit

    A panel-mounted arrestor guarding HVAC boards, appliances and computers.

    $425

  • Generator inlet & interlock

    Outage power for the furnace, sump pump and fridge, with no extension cords.

    from $890

  • Level 2 EV charger installation

    A dedicated 240V circuit for a hardwired wall connector or NEMA 14-50 outlet.

    from$650

  • 200-amp panel & service upgrade

    Old 100A, fuse, Federal Pacific or Zinsco panels replaced with 200A copper bus.

    from $2,450

  • Recessed LED & kitchen lighting

    Clean ceiling layouts, under-cabinet strips and smart dimmers, little patching.

    from $480

Permitted work, neat panels

Behind drywall and inside a breaker panel is no place for shortcuts. Gridline's licensed Master and Journeyman electricians work out the true NEC demand load, read voltage under load and check every GFCI and AFCI before a part is priced, then torque each lug to the maker's spec. You approve a written flat-rate scope first, and nothing outside it is done without a second sign-off.

Panels, boxes & cable runs

The equipment a Gridline electrician opens, tests and labels most weeks, from weatherproof boxes to breaker panels with room left to grow.

  • A grey weatherproof junction box open on a bench, its lid resting beside the gasketed base.
    Gasketed weatherproof box, opened up
  • A row of miniature circuit breakers beside a GFCI breaker in a panel, each circuit numbered on the label strip below.
    Breakers with every circuit numbered
  • Two breaker panels side by side on a wall, one filled with breakers and the other blanked off ready for further circuits.
    Spare spaces left for new circuits

The licensed crew

A state-licensed Master or Journeyman electrician leads every visit. Name a preferred electrician on the contact form and availability is confirmed when the visit is set.

  • The inside of an opened panelboard, its breakers arranged in two columns with each way numbered.

    Dale Ferris

    Founder & Master Electrician

    State-licensed Master Electrician with 19 years in residential and light-commercial power upgrades, NEC load calculations and municipal code compliance. Dale checks every permit calculation himself.

  • A closed metal distribution cabinet on a wall, its door carrying a yellow electrical hazard triangle.

    Nora Vasquez

    Service coordinator

    Sets two-hour arrival windows, files municipal permits and books utility disconnects. Nora gathers panel photos, property type and the symptoms before a van leaves Foundry Row, so the electrician arrives with the right parts.

  • Conduits curving along a service corridor on a working site, with figures working at a distance.

    Marcus Ostrow

    Diagnostics & standby power

    Journeyman troubleshooter trained in Fluke thermal diagnostics. Marcus traces tripping AFCIs, dead outlets and loose neutrals, and wires generator inlets and panel interlocks for storm outages.

  • Two lengths of red cable ducting laid side by side across an asphalt surface.

    Priya Raman

    EV charging & lighting lead

    EVITP-certified Journeyman leading Level 2 EV charger circuits, dynamic load management on 100-amp homes, and recessed LED layouts on Lutron controls.

What Richmond homeowners say

  • Found a charred push-in outlet hidden behind a bookcase in forty minutes, after two handymen could not work out why half our den had died.

    Denise W. · Troubleshooting & code repairs · February 6, 2026

  • Marcus walked me through switching to generator power step by step. When an ice storm took out our street for 36 hours, the furnace and sump pump ran without a hitch.

    Gregory S. · Generator inlet & interlock · March 14, 2026

  • Prompt, respectful and priced upfront. Our whole home-inspection electrical punch list was finished in one Tuesday morning.

    Linnea H. · Surge protection & GFCI retrofit · April 23, 2026

Panels, permits & EV charging

Do I need a 200-amp panel before an EV charger?

Not always. Many 100-amp and 150-amp homes can run a 32-amp or 40-amp charger once a formal NEC load calculation confirms the spare capacity, and a dynamic load-management device covers tighter panels.

Do you charge by the hour?

No. A flat $129 diagnostic covers tracing the fault, the repair is quoted as a fixed figure before work starts, and the diagnostic is credited toward it. Estimates for panels, EV chargers and lighting are free.

Do you pull permits and deal with the utility?

Yes, whenever code requires one. The office files the permit, schedules any meter disconnect and meets the city inspector, so you keep closed-permit paperwork for insurance and resale.

How long is the power off for a panel upgrade?

Most 200-amp upgrades finish in one working day, with the house power off for around half of it in the middle of the day. Closed fridges and freezers stay cold.

Start with a diagnostic visit

Readings first, written down and shown, with the options set out before anything is fitted.

Book a visit Contact the workshop

Notes from the workshop, occasionally

An email when a code change affects domestic boards, or when a seasonal check is worth a reminder. No fixed schedule, and one link in every message removes an address from the list.

This is a demo design, not a real business.Make this design yours for $499 with EZWebee.
What the price includes
The price includes 5 hours of extra work to change the colours, the font family and the font size, add or remove pictures and paragraphs, and add visual effects and other tweaks. The design is 100% finished before anything is paid. Guaranteed.