Heating, cooling and air quality care
Whether a failed capacitor has stalled the outdoor condenser or you are moving to a quiet variable-speed heat pump, every visit starts with measured diagnostics and a price written down before any work is done.
-
Same-day AC & furnace repair
$99
A NATE-certified technician tests electrical amp draws, static duct pressure, refrigerant superheat and subcooling, and flame-sensor microamps to find why a part failed. You see the failed reading and the flat-rate repair price from the printed book before any work begins. The $99 diagnostic dispatch is credited toward the approved repair.
Suits A stalled condenser, a furnace that will not light, a condensate backup or a refrigerant leak, on all major brands, with capacitors, ignitors and ECM motors carried on the van.
Contact about AC & furnace repair -
21-point seasonal tune-up
$139
Real preventive maintenance, never a ten-minute filter check. In spring: condenser coil rinse, condensate trap flush, run-capacitor microfarad test and refrigerant charge check. In autumn: flame sensor cleaned, heat exchanger inspected, digital combustion and carbon-monoxide tests and gas pressure verified. Or $229 a year on the Bi-Annual Comfort Plan.
Suits A system that runs but has not been opened in a year, and any household that wants both seasons covered on one plan.
Contact about a seasonal tune-up -
Airflow balancing & air quality
from $590
Most comfort complaints trace back to undersized return ducts and leaky attic trunks rather than the equipment. We measure total external static pressure, add return-air paths, seal joints with UL-181 mastic, and fit 4-inch MERV-13 media cabinets, whole-home humidifiers or ERV fresh-air ventilators.
Suits One room that will not hold temperature, dry winter air, dust and allergens, or a house where a renovation changed the duct layout.
Contact about airflow & air quality -
Ductless mini-split installation
from $3,850
Independent heating and cooling for rooms the central system cannot reach, or for homes with boilers and no ductwork. Refrigerant lines run cleanly inside colour-matched UV-resistant line-hide channels and are pressure-tested with 500 PSI dry nitrogen. The price is for a single-zone wall or ceiling cassette, installed.
Suits Hot upstairs bedrooms, sunrooms, attic rooms, bonus rooms over garages, home offices and radiator-heated older homes.
Contact about a ductless mini-split -
Heat pump & central AC installation
from $6,800
Oversized air conditioners short-cycle and leave bedrooms clammy, so we size room by room with ACCA Manual J rather than like-for-like. Then a variable-speed inverter heat pump, dual-fuel system or SEER2 central AC, brazed under flowing nitrogen, evacuated below 350 microns, permitted and registered for the full 10-year manufacturer parts cover. The Manual J estimate is complimentary.
Suits Equipment near the end of its life, a failed compressor on an older R-22 system, and anyone weighing a large repair against a replacement.
Contact about a heat pump or AC -
Gas furnace & boiler replacement
from $4,900
Aging, cracked-heat-exchanger or noisy single-stage furnaces replaced with steady two-stage or modulating 80% and 96%+ AFUE heating. Every installation includes a custom galvanised plenum transition, sealed PVC combustion venting, a new gas shutoff and sediment drip leg, digital combustion commissioning and the municipal mechanical inspection.
Suits A cracked heat exchanger, a furnace that is loud or short-cycles, and homes moving from an old boiler or single-stage unit to quieter heat.
Contact about a furnace or boiler
How every service call runs
-
01
Measurement
Readings first: temperature split across the coil, static pressure across the air handler, airflow at the registers, and the condition of the drain and the filter. The numbers are written down and shown.
-
02
Scope and figure
The readings become a written scope with a flat-rate figure from the printed price book. Any part that has to be ordered is named, and the reason the work is needed is stated in plain words. Nothing starts until you approve it.
-
03
Work and handover
The agreed scope is carried out and the same readings are taken again afterwards, so the effect of the work is a measurement rather than an assurance. Anything found on the way is quoted, never assumed.
When a replacement is the honest answer
Clearspan Comfort Works declines repairs that cost more than the remaining life of the equipment is worth, and says so at the visit rather than after the invoice. A cracked heat exchanger, a compressor on an obsolete refrigerant and a system undersized for the building are all replacement conversations, not repair conversations. When you do replace, we help with the available utility rebates and federal Section 25C tax credits and supply the AHRI matched-certificate numbers the filings need.
Start with a diagnostic visit
Readings first, written down and shown, with the options set out before anything is fitted.